Application

1. Remove all dirt, dust and grease from the surface
2. Unroll ± 30 cm and position the film in the right direction
3. Push the film out and remove air bubbles by rubbing by hand from the centre of the film to the outsides
4. Cut to the desired length

Colad Stick & Go® is not conductive. To identify if Stick & Go® is suitable to apply in your ATEX working area, the user has the responsibility to identify and assess the risks involved applying the product in his process, following the ATEX user directive 99/92/EG. Following the requirements in the norm EN 60079-32-1, the user could identify that for gas group IIA & IIB Stick & Go® could be suitable to apply on electrically guiding surfaces as for example stainless steel mixing tables in zone 2, as the product is not thicker than 2 mm. The risks and compliance has to be always assessed by the user, and is by the ATEX user directive 99/92/EG always the responsibility of the user. # Where Stick & Go® is not conductive, it is not suitable to be applied on the floor of a ATEX zoned area (zone 0-1-2 / 20-21-22). ## The user should always identify and asses if the product Stick & Go® is creating risks in his process, it’s the users responsibility to meet the requirements set in the ATEX user directive 99/92/EG and identify if Stick & Go® can safely be used in his process. ### Only people with sufficient knowledge of the ATEX user directive 99/92/EG are allowed to assess the risk in a ATEX zoned area. IN CASE OF DOUBT, DO NOT USE THE PRODUCT AND CONSULT AN ATEX EXPERT!